Single-electrode chips have very high requirements for solid crystal in the packaging industry. For example, in the LED production process, the quality of the solid crystal affects the quality of the finished LED products. There are many factors that cause LED solid crystal cracking. We only discuss the solution of LED solid crystal cracking from three factors: material, machine and man-made.
First, the chip material itself is broken
If the chip breakage is greater than 1/5 of the width of the single-sided chip or the break is at an oblique angle, each side is longer than 2/5 chips or damaged to the aluminum pad. Such chips are unacceptable (this is an item in the chip inspection standard) . The main causes of the bad phenomenon are:
1. The chip manufacturer is not working properly
2. Chip incoming inspection has not been sampled
3. Not picked out during online operation
Solution:
1. Inform the chip manufacturer to improve
2 Strengthen the feed inspection, and reject the chip with too much damage.
3. When the Q test is performed online, the broken chip should be picked out and the good chip should be added.
Second, the LED solid crystal machine is used improperly
1. Improper suction parameters of the machine
The nozzle height and the solid crystal height of the machine are directly controlled by the parameters in the machine computer. The parameters are large, the suction height is small; the parameters are small, the suction height is large, and the chip is damaged or not, which is directly affected by the suction height parameter of the machine. The main reasons for the bad phenomenon are: large parameters of the machine, low hunting height, excessive force on the chip, resulting in chip damage.
Solution:
Adjust the parameters of the machine, and appropriately increase the height of the nozzle or the height of the solid crystal. Adjust the height of the nozzle in the first “Pick Level†in the “Bond head menu†in the “SETUP†mode of the machine, and then in the second item. Bond Level" adjusts the solid crystal height.
High Voltage Laboratory Power Supplies
The LTP series laboratory high-voltage power supply is a high-voltage power supply specially designed for high-voltage laboratory applications with high precision, high stability, and low ripple output characteristics. Built in 19 inches, 2U standard chassis with designed output power at 1KW and output voltage ranges 1KV to 60KV.
After optimizing the output stability and output ripple on the basis of the 1KW high-voltage power module, the stability and ripple of the high voltage lab power supplies can reach the level at 0.1%.
The high-voltage laboratory power supply is also a constant-voltage and constant-current type high-voltage power supply. The output voltage and current can be continuously adjusted from 0 to the rated value via the added control potentiometers added to the front panel, high resolution LEDs display for output KV and mA are also added for intuitive measuring of high voltage laboratory bench.
The lab high voltage power supply is also equipped with DB9 interface as standard. Customers can apply 0-10V signals and dry contact signals to the interface according to our interface definition to achieve comprehensive control and monitoring functions on the power supply, like high voltage start / stop, output setting and reading.
The LTP series laboratory high voltage power supply is equipped with complete protection functions, which can deal with sparking, short circuit, overload, load discharge and other situations.
At present, the high-voltage laboratory power supply is mainly used in Laboratory power, High-voltage test stands, Electrostatics, Capacitor / Insulations testing and Electrophoresis applications.
High Voltage Lab Power Supplies, High Voltage Laboratory Power Supplies, High-voltage Lab Power Supplies, Laboratory High Voltage Power Supplies, Lab High Voltage Power Supplies
Yangzhou IdealTek Electronics Co., Ltd. , https://www.idealtekpower.com