Product calibration
This product should be used after passing the inspection and calibration of the unit with national qualification. The verification method is as follows:
1
The verifier must be qualified for verification.
2
The verification conditions shall be carried out under the constant temperature condition of the product.
3
Should be selected at the time of inspection
3-5
Standard thermometer for root (or above). Insert the standard thermometer into a representative part of the tweezers in the water bath (Note: Do not insert under the tweezers)
4
Read the temperature values ​​above each standard thermometer and calculate the average.
5
,Press
Key, when the temperature display window is displayed
"HSP"
Release, press again
enter
"SC"
Temperature difference adjustment menu. Then follow the average standard thermometer temperature controller to adjust the temperature of the display, such as the mean standard thermometer display is higher than the temperature of the temperature table
1.5
Degree, should be
"SC"
Subtract the original value of the interface
1.5
Degree, and vice versa
1.5
degree. Accurate to
0.1
°C
.
6
,Press
The key returns. Observe the temperature control table to show whether the temperature matches the average value of the standard thermometer. If there is any error, continue to adjust according to the above operation process until the anastomosis.
Stage Lights,Beam Lights,Stage Lights,Moving Head Lights
Guangzhou Chengwen Photoelectric Technology co.,ltd , https://www.cwstagelight.com